Members Demps Posted February 10, 2021 Members Report Posted February 10, 2021 Does anyone have an idea as to what causes it to become difficult to get thread thru feedhole on top of machine to the needle? Does anyone have a parts diagram for this needle/feed assembly? Quote
Members Constabulary Posted February 10, 2021 Members Report Posted February 10, 2021 Do you have a manual? Are you using a threading wire? There is a paddle spring at the end of the needle bar you only an pass with a proper threading wire. Quote
Moderator Wizcrafts Posted February 10, 2021 Moderator Report Posted February 10, 2021 You can buy the same threading wire as is used in Singer patchers. They have a finger loop on top of a thin rod that has a split cut into the bottom. The split holds the thread as you push it through, past he paddle spring, to the needle. Quote
Members Demps Posted February 28, 2021 Author Members Report Posted February 28, 2021 Thank you for your response. Glad to see you can purchase these threading wires thru Amazon. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.