Dannyofalltrades Report post Posted April 14 I just picked up an IMMACULATE Singer 29k-71 and the feed foot won't pull the work through. If I pull it, it goes to the appropriate length and stops, but there is no power going to make the foot pull the work through. Any help is appreciated. 20240414_152612_1.mp4 Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted April 15 6 hours ago, Dannyofalltrades said: I just picked up an IMMACULATE Singer 29k-71 and the feed foot won't pull the work through. If I pull it, it goes to the appropriate length and stops, but there is no power going to make the foot pull the work through. Any help is appreciated. 20240414_152612_1.mp4 @Dannyofalltrades Your video was uploaded in a file format that's not recognized by our board software and cannot be displayed. Please re-save the photo as a .jpg or a .png and re-upload it. Use a small enough resolution to keep the file size under the forum limit. I find that 1:1 and 3x4 produce suitable small size photos. Quote Share this post Link to post Share on other sites
Garyak Report post Posted April 15 8 hours ago, Dannyofalltrades said: I just picked up an IMMACULATE Singer 29k-71 and the feed foot won't pull the work through. If I pull it, it goes to the appropriate length and stops, but there is no power going to make the foot pull the work through. Any help is appreciated. 20240414_152612_1.mp4 Above the foot, there should be a stitch length screw/clamp. It slides up and down the feed bar. All the way down to full feed, up for zero. Quote Share this post Link to post Share on other sites