Consew 205rb

[Moti]

So I have consew 205rb that was in car accident, I completed all the broken parts and assembled them. Now I'm in the Settings phase and I'm getting a little confused because the manual I have isn't very clear. I managed to adjust the feed dog and the walking foot, but now the needle goes in early. It goes in before the foot and feed dog finish moving, and of course that's a problem. How do I adjust this?

[kgg]

2 hours ago, Moti said:

So I have consew 205rb that was in car accident

Here is a good manual ( http://www.consew.com/files/112347/InstructionManuals/205RB-1.pdf  ). I would first get the needle to hook set correctly first, Section 21 page 10 then move on to the feed dog and presser foot.

kgg

[Moti]

14 hours ago, kgg said:

Here is a good manual ( http://www.consew.com/files/112347/InstructionManuals/205RB-1.pdf  ). I would first get the needle to hook set correctly first, Section 21 page 10 then move on to the feed dog and presser foot.

kgg

Hi thank you 

I time the hook and needle but the needle still going down premature

were in the manual they took about timing the needle to the feed dog and walking foot?

 

[CowboyBob]

5 hours ago, Moti said:

Hi thank you 

I time the hook and needle but the needle still going down premature

were in the manual they took about timing the needle to the feed dog and walking foot?

 

Go to page #26,loosen the screws #42 & turn cam #41 (walking foot cam)to adjust.You access it from the backside of the machine.