Members JZC Posted 9 hours ago Members Report Posted 9 hours ago I just designed a logo so I can start stamping my work. I have a line in the logo that is 2.8 pt, so before I go any further I just want to make sure this will be visible/clear when stamped. I'm new to stamping so any help is appreciated! Thank you! Quote
RockyAussie Posted 6 hours ago Report Posted 6 hours ago Best I can tell 2.8 point is just under 1mm and from my experience 1.2mm is a good minimum width for clear stamping but this depends on the overall stamp somewhat. Thinner at the end of lines and in some texts it can still work fine. Quote Wild Harry - Australian made leather goodsYouTube Channel Instagram
Members TomE Posted 1 hour ago Members Report Posted 1 hour ago The folks at The Steel Stamp Co tweaked my logo to make a small impression. Very happy with their work. Quote
Members JZC Posted 1 hour ago Author Members Report Posted 1 hour ago Ok, good to know. I will bump up the line pt 1.2mm. I was assuming that wherever you buy the stamp would advise to any necessary change for a clean impression. I will check out The Steel Co. If there is anyone else that has a favorite stamp co I would to check them out. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.