Singer 45B

[steadybrook]

Does anybody use a Singer 45B long arm for sewing.I need feed back on one of these machines.

[CowboyBob]

The 45B is a Consew 756 & it should sew up to 3/4" & has a walking foot needle feed ,BUT there isn't any other feet or needle plates available for it other than standard.It takes the same shuttle & bobbins as 441's & Adler 205-270's

Bob

[steadybrook]

Thanks.Where can I get a manual for the Singer 45B?

[cowboyjohn]

Does anybody use a Singer 45B long arm for sewing.I need feed back on one of these machines.

Hi,

I have a Singer 45B6BC, cylinder 16 inch arm machine, very powerfull and a much better build quality than modern Chinese machines, but it dos'nt have a walking foot. I fitted a wheel foot which helps but no way will it feed skirts with fleece on. It will put in a padded seat and make up doubled and stitched offbillets but for saddle making with a modern machine you realy need a unison feed.

[steadybrook]

Hi,

I have a Singer 45B6BC, cylinder 16 inch arm machine, very powerfull and a much better build quality than modern Chinese machines, but it dos'nt have a walking foot. I fitted a wheel foot which helps but no way will it feed skirts with fleece on. It will put in a padded seat and make up doubled and stitched offbillets but for saddle making with a modern machine you realy need a unison feed.

Thanks for your help.

[CowboyBob]

I have a Singer book which lists all the models of these 45B machines,I would scan it but it would probably break the binding so here's the list of models.

45B6BT=bottom feed ,flatbed

45B6C= same as above,cyl.arm

45B7BT=needlefeed,flatbed

45B7BC=same as above,cyl.arm

45B8BT=walking foot needlefeed,flatbed

45B8BC=same as above,cyl.arm

[steadybrook]

I have a Singer book which lists all the models of these 45B machines,I would scan it but it would probably break the binding so here's the list of models.

45B6BT=bottom feed ,flatbed

45B6C= same as above,cyl.arm

45B7BT=needlefeed,flatbed

45B7BC=same as above,cyl.arm

45B8BT=walking foot needlefeed,flatbed

45B8BC=same as above,cyl.arm

Bob the number on the machine is 45B6BC.

Thanks.

[ryano]

Here is a little bit of information and I attached a picture. http://www.industria.../singer/45b.htm

Edited March 14, 2010 by ryano