A Few Recently Finished Ones

[mattsh]

Here are a few that I finished recently.

One for me, which was a test piece for the Glock 19 to get the stitching just right and as you can see I needed to move the corner of the trigger guard up about 1/4", which I did on the IWB with snaps that is pictured below. Sorry the picture is slightly out of focus. My phone camera didn't want to cooperate on this one.

This is for a friend's brother-in-law. As I noted above I adjusted the stitching line and now its much better.

This is for a friend at work. His pistol is actually a stainless Springfield. But boy I sure like how that blued customized Colt looks in there.

[Haystacker]

Wow! That wrong handed rig is a looker. Nice job.

[mattsh]

Thanks Hays. It did turn out really nice, even though its for the wrong side.

[Josh Ashman]

All three look very nice, great job!

Best regards,

Josh

[husker]

That is some nice work. That bottom southpaw rig is nice looking.

[Eaglestroker]

I like your stitching on that belt a lot, what thread size is that? I'm curious what your lining it with as well. Nice work!

[mattsh]

Eaglestroker - I wish I could answer your questions with certainty, but I can't. I should have prefaced the picture with the statement that the belt was not made by me. It is a very nice belt, it was made by a man in Colorado. I was able to buy it cheaper than I could make one, so I did.

The thread looks to be 207 or 138, hard to say since I have never seen those sizes, but I know it is smaller than 277.

The lining would appear to be almost like a chrome tanned leather it is so soft, but like I said, not entirely sure. Sorry.