Members camano ridge Posted December 8, 2014 Members Report Posted December 8, 2014 (edited) If you are refeirng to something like pictured below. It is just a tee nut or chicago screw base, a screw, a cup or finish washer and a piece of rubber gas line hose or similar hose. As you tighten the screw it compresses the hose. The Tee nut will work best as the Chicago screw may rotate when you try to tighten the tension. They are used a lot on kydex holsters. However with a leather holster if they are tightly stitched and properly molded you really don't need a tension screw. Unless you are trying to make a generic holster to fit a couple different gun models or brands. Edited December 8, 2014 by camano ridge Quote https://www.facebook.com/CamanoRidgeCustomLeather?fref=ts
Members srtolly Posted December 17, 2014 Members Report Posted December 17, 2014 I've made a few for the SW9VE. Pancake and avenger with a thumb break. I made a video on the avenger. I'll dig this weekend and see if I can find the pattern. I also have an IWB that I can easily adapt to a thumb break. I've made a few for the SW9VE. Pancake and avenger with a thumb break. I made a video on the avenger. I'll dig this weekend and see if I can find the pattern. I also have an IWB that I can easily adapt to a thumb break. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.