Members thekid77 Posted June 21, 2015 Members Report Posted June 21, 2015 Hi everyone, I am making my first pair of spur straps The pattern says to fasten down the 3c buckle end with a double cap rivet. Every time i've set on of these, I've been able to work the rivet apart with my hands..... I am making these for a friend and have safety concerns......what happens if the rivet fails when riding? What are the dangers? I'm ignorant when it comes to horse gear, tack etc Thank you!! Quote
Members BondoBobCustomSaddles Posted June 21, 2015 Members Report Posted June 21, 2015 When riveting those parts that will receive some heavy stress, I always use solid copper rivets with washer. It is best for peace of mind. You don't want your friend losing an expensive spur, for the price of a good rivet. Bob Quote
Members TomG Posted June 21, 2015 Members Report Posted June 21, 2015 Rivets can fail if either too long and are bent when setting, or too short and don't flare properly. Recommended height of the post is 1/16 inch above the pieces you're joining. But Bob is right. For max strength, use copper rivets with the washer Tom Quote
Members thekid77 Posted June 21, 2015 Author Members Report Posted June 21, 2015 When riveting those parts that will receive some heavy stress, I always use solid copper rivets with washer. It is best for peace of mind. You don't want your friend losing an expensive spur, for the price of a good rivet. Bob Rivets can fail if either too long and are bent when setting, or too short and don't flare properly. Recommended height of the post is 1/16 inch above the pieces you're joining. But Bob is right. For max strength, use copper rivets with the washer Tom Thank you, Bob and Tom, for weighing in with your advice!! Have a great day!!! Quote
Members thekid77 Posted June 21, 2015 Author Members Report Posted June 21, 2015 When riveting those parts that will receive some heavy stress, I always use solid copper rivets with washer. It is best for peace of mind. You don't want your friend losing an expensive spur, for the price of a good rivet. Bob Rivets can fail if either too long and are bent when setting, or too short and don't flare properly. Recommended height of the post is 1/16 inch above the pieces you're joining. But Bob is right. For max strength, use copper rivets with the washer Tom btw, what do you guys think of using solid brass rivets (the kind that you peen over a brass washer? I found some solid brass rivets and washers in # 9 and #12 size...... are they equally strong? Quote
Members TomG Posted June 21, 2015 Members Report Posted June 21, 2015 That sounds like the copper rivets we were discussing.http://www.nrsworld.com/prodimages/7730-DEFAULT-l.jpg Quote
Moderator Art Posted June 22, 2015 Moderator Report Posted June 22, 2015 Kid, Bob and Tom were talking about copper burr rivets. They are sufficiently strong for the most enduring applications. However, I have some that are Brass, which you might be talking about. These are the devil to clip to length, and about equally hard to peen. They do however have a much nicer looking head although it is a little smaller than a copper rivet, you can set a burr on the rivet before putting it into place and setting the capturing burr (the one you use normally). You might need a Dremel or really big pliers to clip them off, I use heavy duty compound pliers and they are still hard to clip. Art Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.