3248tm Report post Posted October 8, 2018 Not sure what went wrong with lace work here. It starts out very strait then starts to angle a lot. Never had this issue before. I'm guessing it's the curve of the coaster that's causing my problem. Quote Share this post Link to post Share on other sites
Northmount Report post Posted October 8, 2018 It always takes on a slope as continue the lacing. I always take out the first few stitches when I connect back up. The circle accentuates the slope. You could use the same hole 5 holes or so, or just accept it and take out several of the beginning stitches until the slope matches up. Tom Quote Share this post Link to post Share on other sites
3248tm Report post Posted October 8, 2018 Thanks for the input. Quote Share this post Link to post Share on other sites
