Members 3248tm Posted October 8, 2018 Members Report Posted October 8, 2018 Not sure what went wrong with lace work here. It starts out very strait then starts to angle a lot. Never had this issue before. I'm guessing it's the curve of the coaster that's causing my problem. Quote
Northmount Posted October 8, 2018 Report Posted October 8, 2018 It always takes on a slope as continue the lacing. I always take out the first few stitches when I connect back up. The circle accentuates the slope. You could use the same hole 5 holes or so, or just accept it and take out several of the beginning stitches until the slope matches up. Tom Quote
Members 3248tm Posted October 8, 2018 Author Members Report Posted October 8, 2018 Thanks for the input. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.