What am I doing wrong?

[KennethM]

Update:

 

So I had some free time today.Trying to figure some things out.Techsew techsupport is looking into my emails

 

I started following the sailright sewing machinw manual to try to figure some things out

 

I first at trying to proplery balance the pressure feet alternating height

 

So I set the otter pressure goot to lift 4mm and the inner to lift 2-3mm per the sailright manual.

 

Then by hand I did a stitch per inch test.

 

I noticed going forward I am now more consistent of about 7 Mm but the last puncture looks to be closer to 8 mm.

 

Then when I go in reverse and pray that I go through the same holes ..well I dont I make new stitching holes..check out this photo..

 

All and any help is welcomend

[kgg]

This I think is a mechanical problem not a needle problem. Techsew should help guide you through correcting the problem.

[KennethM]

So far techsew has not been the greatest help per say..

 

I sent them photos of the wallet asking for advice on what went wrong and how can I fix the issue or avoid the issue .As I am having the ssme problem on every wallet regardless of needle.

 

Mind you my needle stitch lenght is not accurate either..this is what they email me.

 

 

[KennethM]

Here's another issuie I am having

 

https://www.dropbox.com/s/sthq279elkx3wa8/0114191453.mp4?dl=0

[Techsew Ron]

  On 1/15/2019 at 2:10 AM, KennethM said:

So far techsew has not been the greatest help per say..

 

I sent them photos of the wallet asking for advice on what went wrong and how can I fix the issue or avoid the issue .As I am having the ssme problem on every wallet regardless of needle.

 

Mind you my needle stitch lenght is not accurate either..this is what they email me.

 

 

Expand  

Hi Kenneth, we're promptly responding to everyone of your questions by email and offering a number of recommendations for adjustments. We would like you to try leather specific needles (LL or S or Diamond point) to decrease the puncture marks on the bottom. Please try our suggestions and let us know the results.

Ron

 

[KennethM]

https://www.dropbox.com/s/sthq279elkx3wa8/0114191453.mp4?dl=0