Members Jbrandon Posted January 10, 2019 Members Report Posted January 10, 2019 Ok so I've made several belts but only a few with names on the backs (centered). I made one for a Christmas gift this year and the name wasn't centered. The customer messed up a measurement but not by enough to throw the name off that much. So how do you do it? Center the name based on the measurement from the fold to the hole they use or based on the measurement from the buckle to the hole they use? Maybe I'm putting too much thought into this but I'm remaking the belt and don't want to mess up again. Quote
Members Dwight Posted January 10, 2019 Members Report Posted January 10, 2019 (edited) CENTER of the buckle, . . . tothe the hole most used, . . . divide that dimension in half, . . . that is your center point for the name. May God bless, Dwight Edited January 10, 2019 by Dwight Quote If you can breathe, . . . thank God. If you can read, . . . thank a teacher. If you are reading this in English, . . . thank a veteran. www.dwightsgunleather.com
Members Hildebrand Posted January 11, 2019 Members Report Posted January 11, 2019 If you have the belt that was wrong you should be able to just measure over however much you were off and re do it. Then use that belt as a guide to let you know how to measure for your style of work. Todd Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.