Jbrandon Report post Posted January 10, 2019 Ok so I've made several belts but only a few with names on the backs (centered). I made one for a Christmas gift this year and the name wasn't centered. The customer messed up a measurement but not by enough to throw the name off that much. So how do you do it? Center the name based on the measurement from the fold to the hole they use or based on the measurement from the buckle to the hole they use? Maybe I'm putting too much thought into this but I'm remaking the belt and don't want to mess up again. Quote Share this post Link to post Share on other sites
Dwight Report post Posted January 10, 2019 (edited) CENTER of the buckle, . . . tothe the hole most used, . . . divide that dimension in half, . . . that is your center point for the name. May God bless, Dwight Edited January 10, 2019 by Dwight Quote Share this post Link to post Share on other sites
Hildebrand Report post Posted January 11, 2019 If you have the belt that was wrong you should be able to just measure over however much you were off and re do it. Then use that belt as a guide to let you know how to measure for your style of work. Todd Quote Share this post Link to post Share on other sites
