DavidMillsSaddlery Report post Posted May 31, 2019 (edited) Curious if I’ve got this threaded right? Manual give directions with part numbers... kinda hard to follow? Edited May 31, 2019 by turbotexas Quote Share this post Link to post Share on other sites
DavidMillsSaddlery Report post Posted June 3, 2019 surely there’s some Landis Guys here? Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted June 3, 2019 Sorry. Not me. Quote Share this post Link to post Share on other sites
DavidMillsSaddlery Report post Posted June 3, 2019 4 minutes ago, Wizcrafts said: Sorry. Not me. You’re the guy for the Union I have lol Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted June 3, 2019 Don't forget back when these machines were made they never knew about this new-fangled nylon twisted thread,so I think you have so much pressure @ that point it's pinching the thread too much,try a lighter spring.I've ran them with nylon & never had any trouble. Quote Share this post Link to post Share on other sites
DavidMillsSaddlery Report post Posted June 3, 2019 4 hours ago, CowboyBob said: Don't forget back when these machines were made they never knew about this new-fangled nylon twisted thread,so I think you have so much pressure @ that point it's pinching the thread too much,try a lighter spring.I've ran them with nylon & never had any trouble. True, and I’ve played with the adjusting of that spring, but then the thread doesn’t come through the leather bottom like it should? This is an older polyester spool (5-6 years old) I got from Campbell. A 207... the 346 never did this? Quote Share this post Link to post Share on other sites
DavidMillsSaddlery Report post Posted June 3, 2019 might have figured it out? Quote Share this post Link to post Share on other sites
