Stitch length not the same in reverse?

[DavidMillsSaddlery]

Yes, that’s what it took, moving the bottom out further!

I received the manual yesterday, and should have the video that Tony Luberto makes within a day or two… Then I won’t have so many silly questions for y’all!

[RockyAussie]

13 hours ago, CowboyBob said:

Your right & that is what Turbo needs to do get the bracket out more @ the bottom so it shortens the foward stitch.,some machines feed longer in reverse THEN you shim the top.

Thanks Bob. I am now thinking it may be a good improvement if the stitch length indicator plate had a V section in the middle when cast in order to allow the plate to swivel in and out and thereby allow precise adjustments if needed . It probably would need a spring behind the screws as done in the shuttle race body or perhaps a couple of small O rings to stop any loosening off. That would be something an operator could do quite easily without any complicated instructions and perhaps avoid the need to send machines back etc.