Squilchuck Report post Posted September 15 I'm setting 104 rivets with a Little Wonder press. I've tried all kinds of adjustments to set 8/16" steel rivets straight but they nearly always twist or bend. Shorter rivets set fine. Any suggestions? - John Quote Share this post Link to post Share on other sites
dragonhawke Report post Posted September 15 8/16(1/2) or 7/32? Quote Share this post Link to post Share on other sites
Squilchuck Report post Posted September 15 Half inch set into a cap, not splash anvil. Quote Share this post Link to post Share on other sites
DomsLeather Report post Posted September 18 My guess is the rivet is too long for the thickness. The rivet should only barely stick though your work piece Quote Share this post Link to post Share on other sites
