Frodo Report post Posted September 25, 2021 Looking for someone that knows their way around a DXF file I need someone who can convert a drawing to a DXF file Quote Share this post Link to post Share on other sites
TomMeyers Report post Posted September 25, 2021 Frodo, from a paper drawing? Lines? How about a photo of it. I would use inkscape. Free and easy. Tom Quote Share this post Link to post Share on other sites
Frodo Report post Posted September 26, 2021 (edited) 15 hours ago, TomMeyers said: Frodo, from a paper drawing? Lines? How about a photo of it. I would use inkscape. Free and easy. Tom thanks for the reply Tom. If you can pull this off you will be my hero. Yes i have a picture of a drawing here it is height of the oval is 48'' width is 24''' This is going to be 3-- 5 1/6 sheets of steel, with the writing on the 1st and 3rd sheet. the center sheet will not be cut out. outer sheets powder coat black center sheet powder coat blue NOTE. the width may have to change to accommodate the width of the lettering/this is understood Edited September 26, 2021 by Frodo Quote Share this post Link to post Share on other sites
TomMeyers Report post Posted September 27, 2021 I double checked: inkscape can output in dxf format. Here is a link with some info. Download inkscape it is free. Tom Quote Share this post Link to post Share on other sites
RockyAussie Report post Posted September 27, 2021 I think you may have forgot the link there Tom. Was curious myself and found this vid which may help some - Quote Share this post Link to post Share on other sites
