CFM Frodo Posted September 25, 2021 CFM Report Posted September 25, 2021 Looking for someone that knows their way around a DXF file I need someone who can convert a drawing to a DXF file Quote
Members TomMeyers Posted September 25, 2021 Members Report Posted September 25, 2021 Frodo, from a paper drawing? Lines? How about a photo of it. I would use inkscape. Free and easy. Tom Quote
CFM Frodo Posted September 26, 2021 Author CFM Report Posted September 26, 2021 (edited) 15 hours ago, TomMeyers said: Frodo, from a paper drawing? Lines? How about a photo of it. I would use inkscape. Free and easy. Tom thanks for the reply Tom. If you can pull this off you will be my hero. Yes i have a picture of a drawing here it is height of the oval is 48'' width is 24''' This is going to be 3-- 5 1/6 sheets of steel, with the writing on the 1st and 3rd sheet. the center sheet will not be cut out. outer sheets powder coat black center sheet powder coat blue NOTE. the width may have to change to accommodate the width of the lettering/this is understood Edited September 26, 2021 by Frodo Quote
Members TomMeyers Posted September 27, 2021 Members Report Posted September 27, 2021 I double checked: inkscape can output in dxf format. Here is a link with some info. Download inkscape it is free. Tom Quote
RockyAussie Posted September 27, 2021 Report Posted September 27, 2021 I think you may have forgot the link there Tom. Was curious myself and found this vid which may help some - Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.