Hi all!
Second post here. I recently ordered a 6-7oz tooling shoulder from Tandy Leather Factory. The quality is fine, not amazing, but fine for what I'm doing with it. However, I wanted to see how some black dye would look on it so I cut some scrap off of it and tried to dye it (Gloves, wool dauber) and I found that the dye mostly just pooled on the surface of the grain and barely absorbed in. I could get it fairly well in after MANY coats, but I'm wondering why this is happening? It DOES look quite smooth, but is that it? I tried it out with an old round I had and the scrap side by side and the round absorbed the dye straight away but the newer shoulder just had dye sitting on top... Any advice? Will I need to sand it down or something?
Concerned,
R.