Orrrmygod

Would it fit like the photo attached?

Hi Constabulary, thank you very much for your help so the set of the binding that you sent (bracket, feed dog, throat plate and binding foot) will work with my PFAFF 345? Thanks

Hi Constabulary, thank you very much for your help. The set of the binding that you sent (bracket, feed dog and throat plate) will work with my PFAFF 345? https://www.ebay.com.au/itm/Binder-Bracket-Walking-Foot-Needle-Plate-Feeder-For-Pfaff-1245-Binding-Sewing-/293054013906 Do you have PFAFF 345 and 1245 that's why you know?

Hi Boro, very nice machines you've got!! I have the same machine PFAFF 345 and I've been looking for a binding bracket. Would you like to sell one of your binding brackets? (please) Please let me know, thanks.

Hi Adi, would you mind the share the service manual with me too please? I recently bought PFAFF 345-H3-6/01 CLN. Thanks

Thanks a lot guys, I took the machine to mechanic this morning. I can’t wait to get the machine back and start to make something soon. Check out attached photo, my hand stitched wallet.

Hi Wizcrafts, FYI I recently replacing the motor and speed reducer. Please see attached. I hope they are not causing the problem. (There’s no belt when I took the photo.) I’ve been using it and working quite well.

Look like mine (PFAFF 345H3-6/01-CLN) doesn’t have safety clutch or might be in different position. It’s quite different from the movie below

Umm I have no ideas where are tip of latch, groove, clutch bushing and the spring.

Oh Thanks Scoutmom 103, this is might be the way to slove the problem. I don't understand this exactly "until the tip of the latch is positioned exactly above the groove in the clutch bushing. Now push back the spring loaded pin ..." but I'll give it a try.

Hi Guys, I just took the Bobbin out but the middle screw is too tight so I can't pull the pin out. Please see the videos attached. Top.mp4 >> I used hand to crank - you can see the gear at the bottom moved but not the pin. Side.mp4 >> I move the pin by hand and I can see the bottom gear move but not engage with the main gear (that need hand crank) Anyone familiar with this problem please help. Thanks a lot. top.mp4 side.mp4

Hi Constabulary, I'm very new to sewing machine and have no ideas that thread go over bobbin is wrong way. I would love to adjust the machine to the right setting so that it's not go over bobbin but not sure how to do that. Could you tell me how to do it please? The thread size i'm using is 138 which should be fine for this machine.

Hi Mikes, there’s no thread under the bobbin. I think the safety clutch might popped. ( hopefully I didn’t break anything)Do you know how to fix it with cylinder machine. Should I take the rotary pin out? Is it the plate underneath? Thanks

Hi Wizcrafts, please see the video from the link below do you think the plate underneath rotary pin is safety clutch you’re talking about? I might try to take it out and inspect.