Pfaff 335 H2 complete rebuild thread

[suzelle]

  On 5/7/2022 at 12:51 PM, Woehlk said:

Got it to work, thanks for your help :D

Expand  

Yay!!!!!!!

[Woehlk]

I startet centering the needle

But this screw is so stock!, I will try using a screwdriver with hammer funktion later, maybe this can loosing it

[Constabulary]

apply heat with a gas blow torch

[Woehlk]

  On 5/8/2022 at 12:51 PM, Constabulary said:

apply heat with a gas blow torch

Expand  

Wow that actually worked!! Thanks!!!

[Woehlk]

Its like im going in circles a bit  When I adjust one thing, and get it perfect, another seem to get out if sync

Could someone coach me over video? I would gladly pay for you help <3

[Woehlk]

Im getting closer :D its doing something now :D

 

[suzelle]

  On 5/12/2022 at 8:48 AM, Woehlk said:

Im getting closer :D its doing something now :D

 

Expand  

Exciting Stuff! So great to see all your work as you go! Keep it coming! 

[TheMortgageGuy]

  On 5/12/2022 at 1:30 PM, suzelle said:

Exciting Stuff! So great to see all your work as you go! Keep it coming! 

Expand  

question.. where did you get your presser feet? are the ones for this machine the same as the Pfaff 335 H3 and newer Pfaff 335?

 

[shoepatcher]

Feet are not equalized as to the walk.  Put the foot walk on medium lift in the back of machine.  Should be a wing nut and slot on it.  Loosen the two screws on top and the far left on top of the shaft.  That should drop the center foot all the way to throat plate.  By hand , turn the balance wheel towards you until the needle is just entering the feed dog which should be even with the throat plate.  Tighten the 2 screws on top.  Check lift of inner foot and then lift of out foot.  Should be close to equal now  for each foot.

glenn

[Woehlk]

Hi guys!; 

Had to take a break from the machine, Had to work a lot, and also had a vacation,  im like 95% done I think. But this problem, I need your help again. 



Youtube video