TheMackinaw Report post Posted August 22, 2022 (edited) Hi folks, I hope everyone is well. I recently put out a few questions to you re. purchasing an Adler 069-373 - thanks again for your help and patience - well I went ahead and bought one and thought I would share the results with you. I rebuilt the table in 40mm ply (just over 1 1/2") , stained the top, re-fit the head, fit the new 1hp servo motor, added a leather belt, fit the knee lever, fit the lamp, fit the thread holder and finally the draw (not in the pics). Still a bit of work to do - new EDL machine lamp decal and to eventually convert this beautiful machine to a binder - curtesy of KHSew. Will post about that upgrade too. I may build a wooden flat bed for it also.. I really enjoy working on these old machines, I did my Adler 105 and it looks just as good as this on it;s original heavy duty stand. Better photographs of the build here: https://flic.kr/s/aHBqjA3Xed Thanks for looking, keep up the good work Thomas Edited August 22, 2022 by TheMackinaw Quote Share this post Link to post Share on other sites
Emery Report post Posted March 27, 2023 On 8/22/2022 at 11:06 AM, TheMackinaw said: Hi folks, I hope everyone is well. I recently put out a few questions to you re. purchasing an Adler 069-373 - thanks again for your help and patience - well I went ahead and bought one and thought I would share the results with you. I rebuilt the table in 40mm ply (just over 1 1/2") , stained the top, re-fit the head, fit the new 1hp servo motor, added a leather belt, fit the knee lever, fit the lamp, fit the thread holder and finally the draw (not in the pics). Still a bit of work to do - new EDL machine lamp decal and to eventually convert this beautiful machine to a binder - curtesy of KHSew. Will post about that upgrade too. I may build a wooden flat bed for it also.. I really enjoy working on these old machines, I did my Adler 105 and it looks just as good as this on it;s original heavy duty stand. Better photographs of the build here: https://flic.kr/s/aHBqjA3Xed Thanks for looking, keep up the good work Thomas That looks awesome. I just got same machine and needing to get all the binding items. On your other post was it the four items that Uwe Posted that you needed or can you share what KHSew stuff you purchased? I have bought from them before for my Seiko. Quote Share this post Link to post Share on other sites
Hags Report post Posted March 29, 2023 Very neat! Quote Share this post Link to post Share on other sites