glockanator Report post Posted August 26, 2023 Was asked to make a panel for aGalco sholder holster. The new panel is to hold a Short Barrel Shotgun. The customer dubbed it the Tubbs rig based on Miami Vice. I also made the strap for his SBS as well. Quote Share this post Link to post Share on other sites
RVM45 Report post Posted August 27, 2023 Cool! Quote Share this post Link to post Share on other sites
chuck123wapati Report post Posted August 27, 2023 very cool!! Quote Share this post Link to post Share on other sites
GrampaJoel Report post Posted August 27, 2023 Mean no offense. But I can pretty much see of all the Galco unit. But your addition is pretty much covered up by the shotgun. Why not unload the shotgun and shells and show up what you did yourself. Joel Quote Share this post Link to post Share on other sites
Hags Report post Posted August 28, 2023 Pretty cool. The zombie apocalypse is nearer than you think! Quote Share this post Link to post Share on other sites
glockanator Report post Posted September 1, 2023 On 8/27/2023 at 4:42 PM, GrampaJoel said: Mean no offense. But I can pretty much see of all the Galco unit. But your addition is pretty much covered up by the shotgun. Why not unload the shotgun and shells and show up what you did yourself. Joel None taken. Didnt think I had one of just the panel. But I just found one. Quote Share this post Link to post Share on other sites
chiefjason Report post Posted September 1, 2023 Well done on the rig. But your buddy stamped a single shot? Got a buddy that made one similar for an SBS 870. Quote Share this post Link to post Share on other sites
David83 Report post Posted February 29 I just found this thread after watching a youtube short about this exact same holster. How much would this panel run me if I wanted to order one? https://www.youtube.com/shorts/XEycXG3CiOI Thanks. David Quote Share this post Link to post Share on other sites
