Juki LS 1341

[toxo]

4 hours ago, shoepatcher said:

Also consider Adler 269.  In same class as the Juki 1341, 1342.

glenn

Oh no Glenn. Has a lift UP reverse. Also Adler accessories are expensive.

[shoepatcher]

269 a great machine.  i had one.  Parts for the Juki 1341,1342 are not that cheap as well.

glenn

[toxo]

2 hours ago, shoepatcher said:

269 a great machine.  i had one.  Parts for the Juki 1341,1342 are not that cheap as well.

glenn

Are the presser feet on the 1341 the same as the singer 111 cos I've got all of them.

[shoepatcher]

Yes   Singer 111 feet fit 1341 machines

[toxo]

2 hours ago, shoepatcher said:

Yes   Singer 111 feet fit 1341 machines

Oh that's great news,  not least because I put the old Durkopp 239 flatbed together for selling and blow me it was sewing perfectly. And I have all the weltng feet in all the sizes and and all the spring loaded guides left and right  

So I think it's gonna be the Adler 69 That's gonna make room for the LS 1341

I do have an error to put right.  The reverse on the 239 is pull down but it is high up.

[MDeBo]

Hi- I am in the market for a used Juki LS-1341. Can anyone tell me the price range I should expect for a good condition machine with stand and servo motor?

Matt

[MDeBo]

Hey Guys-

New on here so forgive me if this has been answered. I am in the market for a pre-owned Juki LS-1341 in the US. What range should I expect to pay for a well-maintained and well-functioning machine?

 

Matt

[Northmount]

10 hours ago, MDeBo said:

Hey Guys-

New on here so forgive me if this has been answered. I am in the market for a pre-owned Juki LS-1341 in the US. What range should I expect to pay for a well-maintained and well-functioning machine?

 

Matt

Give the fellows some time to see your request.  They aren't sitting in front of their devices waiting on you.  This is a worldwide forum, 8 hours isn't enough to go around once!

[kgg]

11 hours ago, MDeBo said:

Hey Guys-

New on here so forgive me if this has been answered. I am in the market for a pre-owned Juki LS-1341 in the US. What range should I expect to pay for a well-maintained and well-functioning machine?

 

Matt

You didn't say what part of the US you are located as prices can vary a lot depending on your location, the overall condition of the machine and whether it was used in a commercial environment. As a note you could probably get a clone LS-1341 for about the same price or less then what you would pay for good used Juki LS-1341.

kgg

[Northmount]

49 minutes ago, kgg said:

You didn't say what part of the US you are located

According to the IP address, he appears to be in New Jersey.

@MDeBo  Should add your location to your profile so you get answer relative to your location.