Dannyofalltrades Report post Posted April 14 I just picked up an IMMACULATE Singer 29k-71 and the feed foot won't pull the work through. If I pull it, it goes to the appropriate length and stops, but there is no power going to make the foot pull the work through. Any help is appreciated. 20240414_152612_1.mp4 Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted April 15 6 hours ago, Dannyofalltrades said: I just picked up an IMMACULATE Singer 29k-71 and the feed foot won't pull the work through. If I pull it, it goes to the appropriate length and stops, but there is no power going to make the foot pull the work through. Any help is appreciated. 20240414_152612_1.mp4 @Dannyofalltrades Your video was uploaded in a file format that's not recognized by our board software and cannot be displayed. Please re-save the photo as a .jpg or a .png and re-upload it. Use a small enough resolution to keep the file size under the forum limit. I find that 1:1 and 3x4 produce suitable small size photos. Quote Share this post Link to post Share on other sites
Garyak Report post Posted April 15 8 hours ago, Dannyofalltrades said: I just picked up an IMMACULATE Singer 29k-71 and the feed foot won't pull the work through. If I pull it, it goes to the appropriate length and stops, but there is no power going to make the foot pull the work through. Any help is appreciated. 20240414_152612_1.mp4 Above the foot, there should be a stitch length screw/clamp. It slides up and down the feed bar. All the way down to full feed, up for zero. Quote Share this post Link to post Share on other sites
Rallekcm Report post Posted August 9 Hello, just signed up. anyway I have a Singer 29k62 that I picked up that is having the same problem! Did you ever find a solution? Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted August 9 2 hours ago, Rallekcm said: Hello, just signed up. anyway I have a Singer 29k62 that I picked up that is having the same problem! Did you ever find a solution? The O.P. hasn't responded since he posted this, on April 14, 2024. I suggest that you start your own topic. If you upload photos, keep them as small as possible and in .jpg format. Quote Share this post Link to post Share on other sites
shoepatcher Report post Posted August 9 the stitch length clamp is not on properly. Will not feed because of that. glenn Quote Share this post Link to post Share on other sites
Rallekcm Report post Posted 5 hours ago I will start a new thread as suggested above, I am for sure missing the little wedge that slots into the back of the stitch length clamp on the foot leg(?). However when I feed it through by hand stitches are so numerous that it basically perforated cardboard for easy tearing. May start making my own stamps! Quote Share this post Link to post Share on other sites