Interesting "441 Style" Presser Feet for Singer 111w, 153w and similar like 341, 227R and so forth

[amuckart]

Thank you, that’s very relevant to my interests. 

[Constabulary]

seems I´ll get my order within the next few days.... curious me is 😉

[toxo]

On 10/17/2025 at 8:34 PM, Uwe said:

My US based order: 

 

Mine was £25.78 in the UK.

[CdK]

My order is on the way. I preferred to get complete sets, that's the way I roll, as I have needed to modify/finish pieces in the past.

 

[Constabulary]

They have arrived! Took 10 days from China to Germany and no extra charge.

I´m using them on my 111G156.

First glance.... The "fork" foot set works fine and line well with my feed dog - no issues. The right toe foot is touching the thread guide but the one I have installed is not the "original" one I have one from a 211 so that is on me. The left toe foot does not fit into the foot bar. The end that goes into the foot bar fork is a bit thicker than on the other feet It also has a different finish, the other feet fit well. Maybe I´ll do some grinding but I´ll check with the seller first.

The scissors are sharp a hell. I ordered them for just having a pair in my tool box. REALLY SHARP!!!

Edited October 27 by Constabulary

[Constabulary]

cannot edit anymore. Here are some pictures:

 

[toxo]

On 10/26/2025 at 4:44 PM, toxo said:

Mine was £25.78 in the UK.

Seems I spoke too soon. Had a card through the door today telling me that the sender hadn't paid enough postage. I've had to pay another £5.50.

[Constabulary]

I'll get a new left toe foot but have to place a new order - thats okay for me considering the fairly low price of the feet. They for sure have something I could use.

I also found some interesting cheap feet for the Adler 67, 167, 68, 168, 69, 169, 267 and so forth "line" in their store:

https://de.aliexpress.com/item/1005008687919538.html

nutin for me Singer Idjit but looks like a good deal for the Adler folks 😉

Edited November 1 by Constabulary

[CdK]

On 10/27/2025 at 8:41 AM, Constabulary said:

cannot edit anymore. Here are some pictures:

 

@Constabulary Variations like what you found seems to be somewhat common with some items I got from the orient in the past. Also the lack of good finish on parts, such as presser feet for the 801 bell skiver, have been a minor irritation but not uncommon even from touted & expensive US manufacturers/resellers. I'm fortunate that I have the tools and skills to finish or modify items to get them to work properly. BTW, the items I ordered are now in country and should arrive in about a week.

[CdK]

I received the 3 sets I ordered today. The L & R and needle feet fit fine but there is a difference in design and finish between the L & R but should work as intended. The "both" foot needed a touch with a Dremel stone to open up the width of the fork by the screw hole to allow the screw to pass through the hole, about 0.1mm. I've had this with some other feet sets in the past so no surprise.