BDAZ Report post Posted December 16, 2014 I replaced the bobbin spring with one obtained from Bob at Toledo and the machine is PERFECT! Loking from the top, you can not see the transition from two layers to a single layer. In addition, my products requires 60" of stitching around the circumference and every time, when I get back to my starting point, the machine drops the last two stitches in the same holes as the first two! Cya! Bob Quote Share this post Link to post Share on other sites
Colt W Knight Report post Posted December 16, 2014 Good deal Good deal Quote Share this post Link to post Share on other sites
wlg190861 Report post Posted January 14, 2015 I have a Cowboy 4500 an have no problem one two or even three layer. you need to use a smaller needle for 207. You need a 23. I have my bobbin tension almost all the way tight and the rest of the tension is done on top. Like was mentioned test on a piece of 5 oz and get it set right and you should have no problem Quote Share this post Link to post Share on other sites
BDAZ Report post Posted January 14, 2015 The problem was transitioning from 1 to 2 layers without a major reconfiguration of the tension and all is now working fine. Thanks! Bob Quote Share this post Link to post Share on other sites
wlg190861 Report post Posted January 14, 2015 Great Quote Share this post Link to post Share on other sites
