Jump to content

Recommended Posts

  • Replies 21
  • Created
  • Last Reply

Top Posters In This Topic

  • Moderator
Posted
6 hours ago, MFloyd said:

Gentlemen, I also have a Problem with my Singer 211G155.... I would like to slow it down a bit. I was wanting to replace the 4in. pully with a 2in. pully....Problem, I don't have a clue where to find a 2" pully. Could any of you guide me to a place that I could acquire one.   Thanks a lot.... MFloyd

I have a similar machine in my leather and sewing shop. The machine pulley is a fixed size. You probably want to replace the motor pulley with a 2 inch pulley. You need to measure the diameter of the shaft, then eBay it. Or, order from one of our supporting dealers, like @CowboyBob. I think that clutch motors have a 3/4 inch shaft, while most servo motors are 15mm diameter. Once you know the diameter, order the small pulley and also get a new v-belt that is that much shorter. The old belt will be too long and the motor may not have enough adjustment to compensate. V-belts have their length stamped somewhere on the outside. A typical -belt for a 4 inch motor to 4 inch machine pulley like your setup might be 44 inches. But, it could be less. The new belt would be 2 inches shorter if you get a 2 inch motor pulley.

Posted IMHO, by Wiz

My current crop of sewing machines:

Cowboy CB4500, Singer 107w3, Singer 139w109, Singer 168G101, Singer 29k71, Singer 31-15, Singer 111w103, Singer 211G156, Adler 30-7 on power stand, Techsew 2700, Fortuna power skiver and a Pfaff 4 thread 2 needle serger.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...