kennedyk Report post Posted January 20, 2017 Hi all, I'm new to the forum and curious if someone can help me out with a pattern for a deck box for the game magic the gathering. Quote Share this post Link to post Share on other sites
cjartist Report post Posted January 20, 2017 Your picture is the same as the thumbnail for this video I watched on Youtube https://www.youtube.com/watch?v=UkvEuJYc2VM Quote Share this post Link to post Share on other sites
Tugadude Report post Posted January 20, 2017 Easy enough to reverse engineer. Get some card stock and start folding. But add your own touches to make it your own. Quote Share this post Link to post Share on other sites
kennedyk Report post Posted January 20, 2017 2 hours ago, cjartist said: Your picture is the same as the thumbnail for this video I watched on Youtube https://www.youtube.com/watch?v=UkvEuJYc2VM I was working on reverse engendering it but i kept messing up on dimensions and got fed up, any tips ? Quote Share this post Link to post Share on other sites
kennedyk Report post Posted January 20, 2017 24 minutes ago, Tugadude said: Easy enough to reverse engineer. Get some card stock and start folding. But add your own touches to make it your own. im not yet good at stitching so a basic pattern for riveted box like this would be quite helpful Quote Share this post Link to post Share on other sites
MADMAX22 Report post Posted January 20, 2017 4 minutes ago, kennedyk said: I was working on reverse engendering it but i kept messing up on dimensions and got fed up, any tips ? Make a square of wood the dimensions you need the inside to be, take thick cardboard and start folding it around tacking it in place. Make cuts and what not till it looks about right. Take the cardboard off and lay flat and there you go, fine tune it and your good to go. Al Stohlmans books on case making are very out dated "however" are very good for getting the basics figured out that you can apply to other projects. Quote Share this post Link to post Share on other sites
kennedyk Report post Posted January 20, 2017 2 minutes ago, MADMAX22 said: Make a square of wood the dimensions you need the inside to be, take thick cardboard and start folding it around tacking it in place. Make cuts and what not till it looks about right. Take the cardboard off and lay flat and there you go, fine tune it and your good to go. Al Stohlmans books on case making are very out dated "however" are very good for getting the basics figured out that you can apply to other projects. thanks I will give it a try and post my results, I also realized i brutalized the spelling of engineering Quote Share this post Link to post Share on other sites
cjartist Report post Posted January 20, 2017 Take a thin piece of cardboard or poster board. Lay your deck box face down near the bottom. Trace it. Without moving the box, tip it up on end, trace. Tip it on its back, trace. Tip it left, trace, etc. Quote Share this post Link to post Share on other sites
