Members Constabulary Posted January 16, 2018 Members Report Posted January 16, 2018 usually the axle is split and you can simply bend the 2 prongs with a screw driver to fit the bobbins - the shown modification is not necessary. Quote ~ Keep "OLD CAST IRON" alive - it´s worth it ~ Machines in use: - Singer 111G156 - Singer 307G2 - Singer 29K71 - Singer 212G141 - Singer 45D91 - Singer 132K6 - Singer 108W20 - Singer 51WSV2 - Singer 143W2
Members Brtz Posted January 16, 2018 Author Members Report Posted January 16, 2018 I decided to make it cause I am using a slightly different diam bobbins coming from two machines. If the axle is spreaded enough one bobbin is fixed properly but another is too small - and the opposite; when the first bobbin is too loose. Both bobbins are cutted on the inside edge so the wire spring solving the problem. Does original bobbin winder have the spring? Quote
Members Constabulary Posted January 16, 2018 Members Report Posted January 16, 2018 12 minutes ago, Brtz said: Does original bobbin winder have the spring? table mounted winders for industrial sewing machine usually don´t have springs on the axle - at least I haven´t seen this before. There are some type of machine mounted bobbin winders that may have a small spring if I recall correctly. Quote ~ Keep "OLD CAST IRON" alive - it´s worth it ~ Machines in use: - Singer 111G156 - Singer 307G2 - Singer 29K71 - Singer 212G141 - Singer 45D91 - Singer 132K6 - Singer 108W20 - Singer 51WSV2 - Singer 143W2
Members charbs55 Posted March 20, 2018 Members Report Posted March 20, 2018 I too have the same issue mentioned above with the 11-108 225-15 screws on the left linkage bar of my Pfaff 145. I had them measured as 12-40's so I guess the same size as Uwe said. Mine too are fowled at the head. If anyone finds a source, please post. Quote
Members Brtz Posted August 13, 2018 Author Members Report Posted August 13, 2018 BINGO! This weird screw for the horizontal bar in pfaff 145; 545 is NOT 11-108 225-15. It is 91-000 560-15! you can check it temporarly replacing this screw from the feed dog lifting axle, as I marked on the picture. mine fits perfectly. Regards, Bert Quote
Members Pfaff Posted February 17, 2023 Members Report Posted February 17, 2023 (edited) Screw Pfaff 7/32-40 length 14,5mm old version réf: 91-000 560-15 New version : 11-108 225-15 Edited February 17, 2023 by Northmount Added new version that had been missed Quote
Northmount Posted February 17, 2023 Report Posted February 17, 2023 3 hours ago, Pfaff said: Screw Pfaff 7/32-40 length 14,5mm old version réf: 91-000 560-15 New version : 11-108 225-15 Good to see you joined the forum instead of trying to post under 'report' as a guest. Copied the new version from your report! Hope to hear more from you now as a member. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.