Finishing a belt

[Dwight]

Tom, . . . forget the sprayer for belts, . . . 

Go to Harbor Freight, . . . buy some of their little 1 inch wide bristle brushes, . . . they're about $.50 apiece, . . . mix the resolene 1 to 1 with tap water, . . . brush it on with the little hog hair brush, . . . brush it on in a swirling and back and forth motion, . . . working up a bit of a lather, . . . then brush out the bubbles.

It makes for a really nice finish, . . . not too thick, . . . protects the dye, the wearer, and the leather from sweat.  

I use that process for all my resolene applications.

May God bless,

Dwight

[TomWisc]

Thanks Dwight, that sounds like a technique I could do right now. I look forward to trying the spray idea but brushing is easier for me until I get an airbrush. 

Leather working is new to me and I do not have a bias one way or another regarding what technique is best. I expect everyone gets comfortable with their way of doing things and most likely there are different ways of achieving great results. It is so helpful getting different ideas. Most of what I have learned has been following ideas on this forum and some videos. 

Thanks again to all of you who give great suggestions. 

[charon]

I think the key is to try all things yourself and make your own decisions. Since everyone is pushing the resolene/water mix for the back I might give that a shot too, but still I'd recommend to try Tan Kote as well and make your own decisions. I use an old dry T-shirt to apply a thin pure/undiluted coat of TK to the back. Look which way the fibers run (rub with your finger over the leather and see which way the fiber lay down and apply evenly. Go over it in one direction after the application. Works every time for me and still looks good on my belt despite wearing it for a year every day now.

[Outfitr]

I like tan kote on the belt back after dye and firmly burnish it in with a wood hand tool.

[Gabriel Rasa]

I've always used gum tragacanth for the flesh side of my projects because I really like the way it smooths down the fuzzies, but I don't know how waterproof it is. (Most of my projects don't need to be waterproof.) Personally I would not recommend Tan Kote, I've had some bad experiences and been very soured on it. Resolene/water is where my vote goes.

But can anybody weigh in on using gum trag to smooth out the texture of the flesh side, and then resolene on top of that to make it waterproof?

[RegisD]

I have used gum tragacanth on the back side of unlined belts and inside of unlined holsters and it works well.  Haven't used Resolene on the back side but have used Tan Kote.  Tom those are good looking belts and I think belts like those for jeans are more comfortable just like you have them without lining the back.  In time they will feel like an old comfortable shirt... nice and soft.  Good work.