Burnisher attachments

[bikermutt07]

I have the 1/2-5/8 motor shaft version from pro-edge. It is mounted on a motor that is too fast. I keep planning to put it on something slower, but haven't yet. 

That being said, it is a very nice professionally built tool.

[chiefjason]

8 hours ago, Steve75 said:

Chief Jason and Ed in Tx I have been looking at Pro Edge Burnishers and was wondering if you guys would mind sharing which burnishers you use for your various projects.  My apologies for high jacking your thread aroh99.

I have the hole master for my drill press and the round hand burnisher for molding holsters.  The large end is great.  I also use it for any edges that are not dyed.  I've had both for a number of years with no problems.  

[Steve75]

Thanks for sharing chiefjason.  I appreciate the insight.

[JDB]

I got this set on Amazon. I've used the longer one a lot over the last year. I've never even taken the shorter one out of the package. It's handy for doing the edges and flat parts of straps and even some larger sections. You do have to be mindful of friction heat though. If you can see the groove near the tip, that was from letting it sit too long in a hole for a thong. A wiff of smoke and suddenly there was a permanent groove. I still use it all the time though. If it breaks I'm certainly getting another one.