Tmccue3 Report post Posted December 7, 2019 This is my first attempt at a holster ever. It's based off the Alaskan chest rig. I just have to make the strapping. Its for a taurus "4 .357. Quote Share this post Link to post Share on other sites
Dwight Report post Posted December 7, 2019 Pretty good start, . . . Scorpio is upside down though, . . . lol.......... Seriously, . . . go for it, . . . show pics of the finished product. I make one or two of these from time to time. May God bless, Dwight Quote Share this post Link to post Share on other sites
Tmccue3 Report post Posted December 7, 2019 I didn't know about the Scorpion, the only reason I put it facing that way, I figured that's the danger zone hahaha. Thanks Quote Share this post Link to post Share on other sites
chuck123wapati Report post Posted December 7, 2019 Looks great ! I would have run the stitching up around the curves of the frame and trigger guard a bit closer, it may loosen up there a bit. Quote Share this post Link to post Share on other sites
Tmccue3 Report post Posted December 7, 2019 I see what you mean. Thank you. Quote Share this post Link to post Share on other sites
dikman Report post Posted December 7, 2019 Put another rivet in there, you already have one so it won't look out of place. A good start for a first holster, after a while you'll think "hmm, I can do better so I'll make another" and before you know it you're hooked! Quote Share this post Link to post Share on other sites
Dwight Report post Posted December 9, 2019 Here is the "pattern" I use, . . . I use the moniker of "Trucker" when I'm working on an order with someone. That is suede for the lining. May God bless, Dwight Quote Share this post Link to post Share on other sites
