DanishMan Report post Posted February 14, 2020 I finally managed to take apart the knife shaft Quote Share this post Link to post Share on other sites
DanishMan Report post Posted February 14, 2020 Quote Share this post Link to post Share on other sites
Scoutmom103 Report post Posted February 14, 2020 Nice. That's a big change from how it looked. What type of paint did you use? Will you be sharing pictures of how it goes back together as well? Quote Share this post Link to post Share on other sites
DanishMan Report post Posted February 14, 2020 Hi Scoutmom For the inside, I used a normal metal paint. For the outside, I used Hammorite primer and a danish hammorite paint. It looks really good. Kind regards Søren Quote Share this post Link to post Share on other sites
jimi Report post Posted February 14, 2020 Oh! that looks nice Soren... I like that orange inside.... Quote Share this post Link to post Share on other sites
DanishMan Report post Posted May 11, 2020 I have been working on various PFAFF machines, so I have not had time for the skiving machine. However, I as am waiting for parts for my PFAFF 335 restoration, I have time to work on the Dania skiving machine. I am planning to fit two motors in order to give it independent feed. Also, I heard of someone, who had modified a vacuum cleaner to make it fit to a skiving machine. Anyone heard of this? Kind regards Soren Quote Share this post Link to post Share on other sites
Scoutmom103 Report post Posted May 11, 2020 Would you be so kind to put up pics as you put the skiver back together? And any mods you make like the two motors and a vacuum extractor. Quote Share this post Link to post Share on other sites
DanishMan Report post Posted May 13, 2020 Hi Scoutmon I will do that. Kind regards Søren Quote Share this post Link to post Share on other sites
DanishMan Report post Posted May 14, 2020 (edited) Starting to put the machine back together. I took apart in August, so it takes a bit of time to figure out, where the different screws go. Edited May 14, 2020 by DanishMan Quote Share this post Link to post Share on other sites
DanishMan Report post Posted May 14, 2020 (edited) Edited May 14, 2020 by DanishMan Quote Share this post Link to post Share on other sites
Scoutmom103 Report post Posted May 14, 2020 Hi DanishMan, Thank you for posting the pics of it going back together. Quote Share this post Link to post Share on other sites
jimi Report post Posted May 15, 2020 Ohhhh...Looking good Soren... Quote Share this post Link to post Share on other sites
bryan4christ Report post Posted May 16, 2020 beautiful !!! Does it run as good as it looks? Quote Share this post Link to post Share on other sites
DanishMan Report post Posted May 16, 2020 Hi Bryan Not yet - a few steps forward and then a few steps back. But I will get there. Cheers Quote Share this post Link to post Share on other sites
DanishMan Report post Posted May 16, 2020 99% done now. I only need to find a bakelite knob and a spring. And then to prepare the table and motors Quote Share this post Link to post Share on other sites
Scoutmom103 Report post Posted May 16, 2020 looking very nice. Did you have a engineers manual for this, or trial and error? Quote Share this post Link to post Share on other sites
DanishMan Report post Posted May 17, 2020 Hi Scoutmon This is my fourth skiving machine, so I am getting to know the basics. I have three more to restore. Kind regards Søren Quote Share this post Link to post Share on other sites
sainte Report post Posted June 27, 2020 Hello DanishMan, I had not seen your post !. Congratulations! It's a great job. Brds Quote Share this post Link to post Share on other sites
