Dbz456 Report post Posted 22 hours ago https://imgur.com/a/2jKMfS7 I just got this juki 1541 i oiled it up and when i use the knee lift it makes sound that doesn’t sound right it also makes that sound when sewing it’s almost as if the motor sometimes stops becuase something is obstructing is this normal Quote Share this post Link to post Share on other sites
kgg Report post Posted 14 hours ago (edited) 8 hours ago, Dbz456 said: i oiled it up and when i use the knee lift it makes sound that doesn’t sound right Definitely not right. Couple of suggestions: i) Remove the belt from the motor and remove the knee lift. Then hand-wheel it. If the noise is eliminated the drive belt was installed to tightly and or the knee lift installed incorrectly. ii) Re-oil the machine putting oil directly into the bearings and any place the metal touches. When oiling like a bearing move the hand-wheel so that you turn the part you are oiling a quarter turn and re-oil until you make a complete revolution. iii) Check for signs of rubbing of metal parts. iv) I would use synthetic transmission oil around the bearings as it will get into the bearing and provide better lubrication then sewing machine oil. v) Was this machine store for a long time or dropped?? kgg Edited 13 hours ago by kgg Quote Share this post Link to post Share on other sites
Dbz456 Report post Posted 10 hours ago https://imgur.com/a/w4JxnpH Uploaded with audio i removed some parts to be able to identify the problem I don’t know if it was dropped and was def sitting for a while I oiled it up disconnected belt and it still gets kinda “stuck” When the hand lift is up the wheel moves smoother but when lift is down it makes continues to make sound Quote Share this post Link to post Share on other sites
Constabulary Report post Posted 10 hours ago (edited) Have you tried playing with the foot lift height. I mean how high the feet raise when sewing? Just a guess... See page 36 in the manual Juki-1541-instruction.pdf Edited 10 hours ago by Constabulary Quote Share this post Link to post Share on other sites
Dbz456 Report post Posted 10 hours ago I have it set on high but i have tried all the settings problem still persists Quote Share this post Link to post Share on other sites