Members chouinardragon Posted August 27, 2010 Members Report Posted August 27, 2010 Hi, I was wondering if everyone heats creaser when making a decorative crease on leather. What adjustable creaser do you recommend? Joseph Dixon? Thank you. Chris Quote
Contributing Member Ferg Posted September 7, 2010 Contributing Member Report Posted September 7, 2010 Hi, I was wondering if everyone heats creaser when making a decorative crease on leather. What adjustable creaser do you recommend? Joseph Dixon? Thank you. Chris I don't. ferg Quote
outcast Posted September 7, 2010 Report Posted September 7, 2010 I never have, but if you can show me why I would want to I just might. Quote
Ambassador Luke Hatley Posted September 7, 2010 Ambassador Report Posted September 7, 2010 Yes, i do heat my edge creaser, not all the time but on special projects. It makes a fine looking edge crease. You will have to experement on the right amount of heat. I use a Heat Gun to heat the edger. Quote
Moderator bruce johnson Posted September 7, 2010 Moderator Report Posted September 7, 2010 Chris, A lot of the old timers heated their creasers. There were special lamps used under a ring or rack to heat them. I have seen the lamps once in a while on Ebay, and think there are some in the Barnsley tools being sold now. I have tried it and it gives a nice burnished effect with minimal effort. When you get the temperature right, they just glide and give a really nice darkened line. The problem was that I only had one creaser I was using it as a sacrifical tool in case the heat/time equation didn't work out so well. It took a little while to reheat and get back to temp and that slowed things down. My old buddy said they used to have a couple going at a time, and it wasn't a problem. Quote
Members tonyc1 Posted September 8, 2010 Members Report Posted September 8, 2010 Yes. I always heat my creasers unless I just want to mark a stitch line. Tony. Quote
Contributing Member UKRay Posted June 22, 2012 Contributing Member Report Posted June 22, 2012 I heat my creaser when I'm working with bridle leather. IMHO it isn't so important with veg tan. The bridle leather is very 'waxy' and the heat helps the creaser to glide over the surface. I have a gas burner circa 1930 attached to a propane bottle that I use for all sorts of hot work (including melting lead for cutting blocks). It is also good for hot embossing skiver for tabletops and desks too. best wishes, Ray Quote
Members awharness Posted June 23, 2012 Members Report Posted June 23, 2012 If I'm creasing a single line I usually don't heat them, but when I'm boxing out keepers I always heat a double line creaser, it helps give it some shape and the double lines look real sharp. I use a torch on my bench, but you have to be careful not to scorch the leather Quote
Members BondoBobCustomSaddles Posted June 23, 2012 Members Report Posted June 23, 2012 Well there you have it! I learned my "something new " for the day, now I can be stupid the rest of the day and not feel so bad!!!! Bob Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.