steelhawk Report post Posted January 6, 2019 I found this knife sheath online somewhere with no info on who made it so I can't ask them. Does anyone know how the sheath is attached to the belt slot piece? Quote Share this post Link to post Share on other sites
fredk Report post Posted January 6, 2019 It looks like the sections with the belt slots are one piece with the rear layer of the sheath Quote Share this post Link to post Share on other sites
alpha2 Report post Posted January 6, 2019 Top piece, welt, and rear piece with loop extensions. 3 layer sheath. Quote Share this post Link to post Share on other sites
chiefjason Report post Posted January 8, 2019 That's probably more than just 3 pieces. But not a complete 4 piece either. Two options. The back piece is grain side out so it can be stamped with flesh side to the body. That's the easy way, but I doubt the sheath is done like that because the belt slots are stitched. And the workmanship is too nice to skimp on that. Most likely the loop is 2 layers with a thin grain side out layer going just into the welt. And the main piece is grain side to the body. That lets you stamp the outside of the loop and would require the loop to be stitched. Quote Share this post Link to post Share on other sites
steelhawk Report post Posted January 9, 2019 Thanks for you're input. Quote Share this post Link to post Share on other sites
