Working area in progress (Will keep updating here)

[Danne]

Tool board is finished. Now i'm just waiting for my new table top.

 

[PastorBob]

Stunning!

[Danne]

4 minutes ago, PastorBob said:

Stunning!

Thank you, I should have said almost finished though. There will be a holder for a hammer (black Hultaforts STFS) and also a holder for rulers. But haven't bought the hammer yet so I don't have the exact dimensions.

Edited September 8, 2021 by Danne

[Scoutmom103]

Very nice.  Love how the warmth of the wood comes out.

[Danne]

4 hours ago, Scoutmom103 said:

Very nice.  Love how the warmth of the wood comes out.

Thank you, I really like the contrast of beech wood against a darker wall. 

[Danne]

An update with the new table top (Ikea Karlby 2.8m in beech wood veneer)

Also a tip (last photo) Ikea Karlby seems to be a quite good table top, and the price is good if you don't need more than 2.4m (Longer and you need to custom order them and quite expensive) The quality feels very good and it's 3mm veneer which makes it possible to sand and oil it again if it gets scratched or dirty from paint and such. But you will have to use a middle leg or reinforcement or it will sag over time, because it's veneer on chip board. I went for a middle leg and two "L-iron bars" 20x20x2mm the reason I also put the leg there is because I prefer to have a leg under my granite plate (It will answer a little better when you use it as a base for punching.)