Cowboy cb3200 needle hitting presser foot

[peanut39350]

Hi, I have recently noticed that my needle is hitting the backside of the hole in the presser foot.  I initially noticed it when I could hear a sound of something dragging when the needle pulled back through the leather and it ended up being a significant burr on the end of the needle.  I replaced the needle and it was no time that I heard the same sound and the new needle had a burr. That’s when I got to looking and found the needle too far to the back of the hole in the presser foot.  Is there a way to adjust the needle forward?  I can’t see any adjustments for this, see the attached picture.

[DieselTech]

I would say your presser foot got bent. I don't know that for sure. But that is my guess. 

I guess your needle bar could be slightly bent, but really doubt that. 

[AlZilla]

This thread is about adjusting the walking feet. Uwe has a video posted and his stuff is usually pretty detailed. Maybe this will give you some food for thought until someone swoops in with the answer.

 

[shoepatcher]

Look at the manual for centering the needle in the inner foot.  That may be off.  I would check that first with the stitch length set at 0.  

glenn

[CowboyBob]

Since the needlebar & foot bar ride in the same casting there's no adjustment,my guess is the foot is bent ,you can either try to bend it backwards alittle or grind it out w/a Dremel of get a new one.

[peanut39350]

Thanks for the replies, I will see about getting a new foot

[Wizcrafts]

22 hours ago, peanut39350 said:

Thanks for the replies, I will see about getting a new foot

@peanut39350

@CowboyBob is the owner of Toledo Industrial Sewing Machines. He is a Cowboy sewing machines dealer and has those feet.

[peanut39350]

Ok thanks @Wizcrafts, @CowboyBob how do I contact you to order one?

[1hp]

https://www.tolindsewmach.com/

you will need to call Bob on monday.

bought a servo motor for my 206rb5 from him. got here fast!

Edited October 13 by 1hp