Toyota LS2-AD331L

[Carlsen Carlsen]

Thanks for let me in, i'm new in this world

Dear All Toyota fans

I need a little help

Q:

What are these 2 "button for the green and red arrow are pointing at?

And how can i freewind so i can only run whit pulleys so I can fill up my bobins

or if someone have a manual i can get will i be grateful

Thx in advance

[kgg]

1 hour ago, Carlsen Carlsen said:

What are these 2 "button for the green and red arrow are pointing at?

The green arrow points to what looks like a oiling port for the internal parts similar to the Juki LU-562 & 563.

The red arrow points to the stitch length adjuster as I don't see a stitch length adjusting dial or it is a safety clutch to protect the hook assembly when you jam up the machine.

1 hour ago, Carlsen Carlsen said:

And how can i freewind so i can only run whit pulleys so I can fill up my bobins

If you want to wind just a bobbin: Here is a link to pretty good video from the 9:00 minute mark ( 

i) remove thread from needle otherwise you will jam the machine up.

ii) the winder needs to be set so it trips out when you get about 80 percent of the bobbin filled.

iii) install empty bobbin on winder shaft. Most bobbins have holes on the sides of the bobbin so a) the end of the thread from the spool of thread you are using to fill the bobbin through the winders tension discs then to the inside of the bobbin outwards through a hole b) push the bobbin trip lever towards the rear of the machine to engage the winders drive wheel up against the machines drive belt c) hold the end of the thread in your hand d) hit the go pedal e) hold the end of the thread until you have at least two complete rows wound on the bobbin.

iv) you really should have two spools of thread one for the top thread and one for the bobbin thread so you don't have to unthread the machine just to wind a bobbin.

kgg

 

[Carlsen Carlsen]

Dear KGG

Thanks for Your reply

pls look at my photo below, this "onewaywheel" blue arrow can be activated by pressing the "red arrows" it's a rubber bottom, and here is what it's look below 

Reverse, 2'nd photo in the lever that the yellow arrow are pointing at, it go reverse by pushing it down, and stitching length are adjusting by a shiny nut in the lever,, I hope it make any sense 🙂

 

[Northmount]

6 hours ago, Carlsen Carlsen said:

I need a little help

I moved your post to Leather Sewing Machines.  This is where the machine guys hang out.

Secondly, your photos are too small to see details.  Resize photos (JPG or PNG) to 800 pixels in the longest dimension.  That will produce files with enough detail and still meet the size restrictions on this site.