Members spurdude101 Posted February 11, 2016 Members Report Posted February 11, 2016 can anyone tell me if they make a welting foot for sewing piping on upholstery for shoe patcher model 29 family? Quote
CowboyBob Posted February 11, 2016 Report Posted February 11, 2016 I've never seen one because it wouldn't feed properly since only the top foot pulls the material.When your sewing upholstery you'll be sewing at least 4 plys of material & it'll shift with just the top feed. Quote
Members spurdude101 Posted February 14, 2016 Author Members Report Posted February 14, 2016 thanks, In theory I suppose you are right. however I have not had too much problems with that happening. As it is the only machine I have I sew all kinds of things on it. sometimes you have to watch and take your time. Quote
CowboyBob Posted February 15, 2016 Report Posted February 15, 2016 You could probably do some upholstery easier if you ground off one side of the foot so you could get closer to the needle. Quote
Moderator Wizcrafts Posted February 16, 2016 Moderator Report Posted February 16, 2016 Presser feet for 29 type machines aren't that expensive. I bought an extra foot online and cut off the left toe. I used to to sew around circular ceramic magnets embedded inside leather pouches and cases. It did a fine job, leaving the needle free to sew right next to the raised area, while not getting dragged in by gravity from the blackhole; I mean magnet... The technique works, whether you are sewing around raised hardware, magnets, or piping. You could probably do some upholstery easier if you ground off one side of the foot so you could get closer to the needle. Why don't you sell the man a presser foot with one toe ground off? I have one I made and it works fine on my patchers. Quote
Members jimi Posted February 17, 2016 Members Report Posted February 17, 2016 http://dixiesewingmachine.tzo.com/MANUALS/SINGERPARTS1/29K1%20TO%20K4,K10%20TO%20K18,K12%20TO%20K23,K30%20TO%20K33.pdf plate 168 part nº 81993 and 81925 were top and bottom feed binders made for the 29k17,18,22,23 no welting as far as i know. maybe you could make a similar one for welting?? when i get time i will surely try to make one for mine. regards jimi. Quote
Members jimi Posted February 21, 2016 Members Report Posted February 21, 2016 And i think plate 164 part #85675 is the other part to the binding setup. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.