Members keithski122 Posted December 26, 2018 Members Report Posted December 26, 2018 20 hours ago, Windchime said: I'm still not sure how to pull the thread under the tension spring when the bobbin case is installed. I'll probably figure it out with practice. When I install the bobbin I put the thread through the slit in the bobbin case, wind the machine over by hand to get the thread to the top, then hold the bobbin still and pull the thread.It will snick into the tension spring.Machine is a juki 563 but may well work on your machine. Quote
Members Windchime Posted December 26, 2018 Author Members Report Posted December 26, 2018 Thanks to all for your advice. I’m amazed that my machine actually sewed the way I was threading it. It worked but it was very temperamental. Today, it stitched perfectly, with no problems. Quote
Northmount Posted December 27, 2018 Report Posted December 27, 2018 5 hours ago, Windchime said: Today, it stitched perfectly, with no problems. Yeah! Quote
DonInReno Posted December 27, 2018 Report Posted December 27, 2018 Good job! I just had a big sense of relief. Lol Quote
kgg Posted December 27, 2018 Report Posted December 27, 2018 That is great news. kgg Quote Juki DNU - 1541S, Juki DU - 1181N, Singer 29K - 71(1949), Chinese Patcher (Tinkers Delight), Warlock TSC-441, Techsew 2750 Pro, Consew DCS-S4 Skiver
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.