HollyMac23 Report post Posted February 19, 2019 Hi, I was wondering if anyone might be able to help me. I am looking for a specific part for a Pearson #6 machine. Unfortunately I don't know much at all about these machines... so if I have got information wrong or I am using the wrong terminology I apologise in advance. The picture I have attached of the part is really low res but it is the metal plate that holds the shuttle in that I am missing. I don't know if the picture is of the same machine but it's the only reference image of a similar part I could find online. Ideally I would love to be able to purchase this part from somewhere (and it doesn't have to be in New Zealand, although that does make it easier) but other wise if there is someone in Auckland that has one of these machines that I could look at and could get a metal worker to make a new part from an existing part. If anyone has any info that could help me even just the right terminology for this part it would be hugely appreciated! Thanks so much! Quote Share this post Link to post Share on other sites
shoepatcher Report post Posted February 20, 2019 Contact Steve at Singermania in Australia. He has the best selection of #6 Pearson's anywhere. glenn Quote Share this post Link to post Share on other sites
plinkercases Report post Posted February 21, 2019 My machine arrived missing the same part. I had to borrow one and have it replicated. Good luck. Quote Share this post Link to post Share on other sites
amuckart Report post Posted February 26, 2019 Hi Holly, To clarify, are you looking for the slide cover that goes on the top? I don't have a No.6 any more but my recollection is that this is a pretty simple part. Given measurements an engineering shop should be able to make one without any difficulty. I'm not sure how active he is on here at the moment, but Gordon Disher is near you and has a handful of No.6'es. Quote Share this post Link to post Share on other sites
gordond Report post Posted February 26, 2019 I'm awake... Just contact- email- me in Auckland or Steve in Aus Quote Share this post Link to post Share on other sites
beaulama Report post Posted March 1, 2019 Hello, I had this machine that I know well enough. It is now in Taiwan but I suppose this is that piece you are looking for. You can buy it here www.aaronmartin.com. Alain. Quote Share this post Link to post Share on other sites
plinkercases Report post Posted March 1, 2019 8 hours ago, beaulama said: Hello, I had this machine that I know well enough. It is now in Taiwan but I suppose this is that piece you are looking for. You can buy it here www.aaronmartin.com. Alain. When I was looking to replace mine I went to Aaron Martin and they only sell the spring and screw which helps latch the plate in place. As I said I had one copied. They left the brass ramp piece square and I shaped it myself using the actual piece on hand and running the shuttle and checking for high spots. Quote Share this post Link to post Share on other sites
Matt S Report post Posted March 1, 2019 @HollyMac23 You could see if @Les No6 has or knows of any sources for your replacement part. He is a font of knowledge on the old girls and has been known to manufacture small runs of some parts before. Quote Share this post Link to post Share on other sites
