Willbury Report post Posted March 31, 2019 I'm wondering if anyone has come across a suspended edge guide for a LU-563 or an adapter to use one of the more generic ones. I've drilled and tapped the body on other machines to make edge guides work, but prefer not to go that route if it can be avoided. Anything out there people are using or have come across? Quote Share this post Link to post Share on other sites
shoepatcher Report post Posted March 31, 2019 You would have to find a flip down roller guide for a singer 111W155 which I do not know if they ever made one. Todays flip down guide will work but it means drilling and tapping I am afraid. glenn Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted April 1, 2019 On 3/30/2019 at 9:05 PM, Willbury said: I'm wondering if anyone has come across a suspended edge guide for a LU-563 or an adapter to use one of the more generic ones. I've drilled and tapped the body on other machines to make edge guides work, but prefer not to go that route if it can be avoided. Anything out there people are using or have come across? Juki kept the same holes in the front & it doesn't have a roller,just a finger that comes down. Quote Share this post Link to post Share on other sites
brmax Report post Posted April 1, 2019 Just sayin Thanks Bob! Now noticing this option on the front is a eye opener. These post sure give an opportunity for many of us. Good day Floyd Quote Share this post Link to post Share on other sites
Willbury Report post Posted April 1, 2019 59 minutes ago, CowboyBob said: Juki kept the same holes in the front & it doesn't have a roller,just a finger that comes down. This would be perfect, any suggestions where to source a guide like this? Quote Share this post Link to post Share on other sites
mikesc Report post Posted April 1, 2019 Juki kept the same holes in the front Singer 211 has the same holes in the same place. Quote Share this post Link to post Share on other sites
Willbury Report post Posted April 2, 2019 Just wanted to follow up with this thread. I was out a my friends shop today and mentioned the edge guide conundrum for the LU-563 and he pulled this out of his drawer and gave it to me. It uses a single existing hole on the backside of the 563 and is stabilized with the pin that holds the front dust cover closed. So these are out there. This one has the following stamped on it: FAE and then 99-116086-23 if that helps anyone find one Quote Share this post Link to post Share on other sites
mikesc Report post Posted April 2, 2019 Ha..That is clever..thank you for the supplementary post, especially for the photos :) Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted April 2, 2019 I've never seen one like that! Looks like it'll work. Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted April 3, 2019 It looks like that edge guide is for a Pfaff machine. I found this listing for it, but no picture. https://www.schmetzneedles.co.uk/99-116086-23-edge-guide-pfaff Quote Share this post Link to post Share on other sites
Willbury Report post Posted April 3, 2019 1 minute ago, Wizcrafts said: It looks like that edge guide is for a Pfaff machine. I found this listing for it, but no picture. https://www.schmetzneedles.co.uk/99-116086-23-edge-guide-pfaff I found that as well but am a bit surprised that a Pfaff would have the same hole and stud placement dimensions, if it had been for a 111 or 211 I wouldn’t question it. There’s nothing else online I can find other than this link without a picture so hard to know for sure. Quote Share this post Link to post Share on other sites
