Narrow feed dog FLAT Plate for Cowboy CB4500 and Cobra 4

[Patrick1]

I do make a #25 for the CB3200 but the demand is low for the 3200 so it's best to contact me directly to see what I have in stock.

[msdeluca]

1 hour ago, Patrick1 said:

I do make a #25 for the CB3200 but the demand is low for the 3200 so it's best to contact me directly to see what I have in stock.

Thanks for getting back to me, but I already ordered one from RockAussie.

Do you make a smooth plate and dog set for the Consew 206RB-5...?

Mike

[Patrick1]

No I'm only making parts for the Juki 441 or 441 clones and the Durkopp -Adler 205. Guess I should clarify, I'm not making any more feed dog and plates for the CB 3200, but my Narrow presser foot set and left presser foot fits the CB 3200.

[shoepatcher]

Patrick   what parts you making for the 205 Adler?

glenn

[Patrick1]

I have the Xtreme #25 feed dog and plate which has a slot width of .160 recommended for a #25 needle and below. The Narrow presser foot set, Also have the streamlined Double presser foot and left presser foot for the Adler 205-370.

 

 

[Doc Reaper]

On 1/5/2023 at 8:09 AM, Patrick1 said:

No, the black oxide coated plates are made of low carbon steel and rust easily if not treated. I still have some black oxide plates in stock and will remove them from my website when they are all sold. The feed dogs are have a black oxide finish and are made of 4142 pre heat treated chrome moly steel. 

How do you treat the black oxide????

[Patrick1]

I'm not making black oxide parts anymore. Everything is now stainless. Any parts I did black oxide was with hot salts cooked in a bath. You can get more info here https://feeds.brownells.com/userdocs/learn/Inst-113 Bluing Booklet.pdf  

[RockyAussie]

On 10/1/2023 at 1:49 AM, Patrick1 said:

No I'm only making parts for the Juki 441 or 441 clones and the Durkopp -Adler 205. Guess I should clarify, I'm not making any more feed dog and plates for the CB 3200, but my Narrow presser foot set and left presser foot fits the CB 3200.

For anyone interested I can vouch that the Narrow presser foot set made by Patric are a very useful addition to have for any of the 441 clones. I have been making and selling molds for wet casting a lot of different pouches which can be seen on my YouTube channel and most of these get stitched using this foot set. You can see on this video where I am using one of Patric's sets stitching up a Leatherman pouch which I have made using the mold I make and sell.

 

[JAM]

Hello, Patrick, do you still have any of the narrow feed dogs and plates left? I have a Cobra 4.

[DieselTech]

2 hours ago, JAM said:

Hello, Patrick, do you still have any of the narrow feed dogs and plates left? I have a Cobra 4.

Look up Hennigan Engineering & Precision, I believe that is the website. 

Edited October 11, 2024 by DieselTech