Best Oblong Punch for Holsters

[WMages]

Looking to further tighten up details on leather holsters I build. I'm getting by currently with a round punch and a slightly too narrow oblong punch but would like to do this in one or two hammer blows. I normally build holsters matched with  either a 1/4" or 5 1/16" belt. Could someone direct me to a good quality punch that will make the slots the size I need in one pass? I've looked at Osborns but haven't been able to determine the width of the slot they cut. I expect to pay a premium price so long as the punch is great quality. Thanks.

 

[fredk]

There was discussion recently which included talk about large oval punches for holsters 

I can't remember where it was or by whom, but if I find it I'll post a link

edit; check this thread out

 

Edited Monday at 10:06 PM by fredk

[bruce johnson]

Here are the dimensions of the new CS Osborne #151 bag/slot/oblong punches.