Constabulary Report post Posted February 19, 2017 Does someone know what purpose this needle plate and feed dog is for? I have not found them in my parts list though I think I have seen these parts before.... Will take a picture of the installed parts later. Quote Share this post Link to post Share on other sites
Matt S Report post Posted February 19, 2017 Is it a holster or stirrup plate? Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted February 19, 2017 I worked on a lot of 45's over the years & have never seen that one.It might of been custom made.I'd say it's for sewing a narrow strap or ?? it looks like 6-8 mm from the needle hole to the rightside? Quote Share this post Link to post Share on other sites
jimi Report post Posted February 21, 2017 Hello Folker, just got back my PC again. "spot the needle plate game? haha" Quote Share this post Link to post Share on other sites
Evo160K Report post Posted February 21, 2017 Jimi, where do you find all of that marvelous literature you have? Sure would like to purchase a copy. Regards Quote Share this post Link to post Share on other sites
Constabulary Report post Posted February 22, 2017 (edited) Ha ha - okay - so its for the Adler 5 / 105. Who els should have that information - thanks again Jimi. I could use a copy too. Jimi, if you cannot attach a PDF please send me a paper copy, I will cover your expenses of course. Edited February 22, 2017 by Constabulary Quote Share this post Link to post Share on other sites
jimi Report post Posted February 22, 2017 (edited) sorry lad´s i only have that picture i found on the net.. no book and this one... As for that plate and feed dog folker, singer used one similar to that ( 1 set of teeth) for the 45k69 and 71. it was for sewing boots. and "did you know that it had the side wheel option like the 29k??". you can see the thread was tensed on the post similar to the rafflenbeul,frobana sole stitchers. in the picture of the plate and feed dog you can see the part next to it is for sliding on the post to hold the thread down on the spring that goes underneath? it can be seen in the illustration also.. 91794 was attached to the right of the needle plate in one of the two holes ( on a 45k21 the holes are used to attach the guide plate) and is also similar to the sole stitchers in the way that you held your threads under it to be able to start with both hands free.... Edited February 22, 2017 by jimi Quote Share this post Link to post Share on other sites
Evo160K Report post Posted February 22, 2017 Fascinating Jimi!! Thank you. Quote Share this post Link to post Share on other sites
