Glueing large areas?

[tH3dOuG]

So i'm in the planning process of making a leather shotgun case which will have Tandy Kodiak leather then closed cell polyethelene padding then an upholstery fabric lining. My everyday adhesive is tanners bond contact cement, but on such a large area, it seems unrealistic to use contact cement, between the leather and foam and then between the foam and the lining. So i'm wondring what some alternatives may be? I was thinking spray adhesive, but have never used it before and not sure what to look for as far as super strength "last a lifetime" spray adhesive goes. All 3 layers will of course be stitched together round the edge of the case, including a zip.

 

Any suggestions would be greatly appreciated!

[Halitech]

I forget the actual name but most auto parts stores carry 3M spray adhesive that is used for headliners/etc. It should work for what you are wanting to do

[Bodean]

[Halitech]

that's the one, thanks Bodean

[Bodean]

50 minutes ago, Halitech said:

that's the one, thanks Bodean

You bet. Stuff works good. I have been using it on leather pieces that are larger. 

[cord1974]

Used it before to glue holsters. Great for a lot of stuff. 

[DrmCa]

3M glues are absolute best, I use their foam glue in the green can all the time to make classic "cheese cutter" caps and it works very well. Unfortunately the cans run out of "air" long before they run out of glue, but I am investigating into the method to re-fill them from a compressor, just need to figure out the moisture removal.

[Mattsbagger]

1 hour ago, DrmCa said:

3M glues are absolute best, I use their foam glue in the green can all the time to make classic "cheese cutter" caps and it works very well. Unfortunately the cans run out of "air" long before they run out of glue, but I am investigating into the method to re-fill them from a compressor, just need to figure out the moisture removal.

Bang the can on the edge of your bench. (Side of can) It works. I don't know why. I've done it with most aerosol cans at some point.Ok to dent  but don't puncture it.lol

Edited January 10, 2018 by Mattsbagger

[DrmCa]

In my case the pressure runs down to 0 PSI so no amount of banging would help. Before these cans are completely low, warming them up under hot water prolongs their life a bit, but not for long.

[brmax]

Theres a brand name, and very old that has specialized to specfics with some adhesives. I just thought to pass what Ive heard from longtime pros. Some points i have heard are foam safe, soft glue line, low soak, hi heat ( i mean arizona landau top hot ). I am not sure if any can be obtained in single cans near you but you may find available somewhere. And to be honest i have also used 3m happily forever, but in the recent past have learned of this company.  

Camie, take a look under industries. 

http://www.camie.com/

good day

Floyd