Jump to content

Recommended Posts

  • Moderator
Posted
8 minutes ago, katit said:

Wiz, all 3 pics different. I'm trying to understand in what position shaft have to be in relation to beak.

The way this knee lifter works is the bent rod pushes on the pivoting crank. If the rod is set too high it can actually push against the body, lifting the head. If it is set too low, it can slide past the "beak" and flop around uselessly. The trick is to position the rod high enough so that it gives the full required amount of lift to the feet, yet does not also push the body itself up. You should have a discoverable range of height that accomplishes these two things.

Posted IMHO, by Wiz

My current crop of sewing machines:

Cowboy CB4500, Singer 107w3, Singer 139w109, Singer 168G101, Singer 29k71, Singer 31-15, Singer 111w103, Singer 211G156, Adler 30-7 on power stand, Techsew 2700, Fortuna power skiver and a Pfaff 4 thread 2 needle serger.

  • Replies 25
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Posted

Get the lift mounted to the table first. It is a bit of trial and error until you find the sweet spot. If the bent rod is too short, it slips past the lifter. Too long and it locks up.

Ferdco Juki Pro-2000, Juki DNU-1541S, LS-1341, LU-563, DLN-9010A-SH, MO-6714S,  Consew 206RB, 206RB-1, Chandler/Bernina 217 6mm w/Cam Reader, Brother LT2-B842-5

  • Members
Posted
17 minutes ago, JJN said:

Get the lift mounted to the table first. It is a bit of trial and error until you find the sweet spot. If the bent rod is too short, it slips past the lifter. Too long and it locks up.

Thats a question. WHERE to mount lift on a table? Is dimension (shaft aligns with motor bolts) accurate? I prefer not to drill table many times if possible..

Posted (edited)

Yes, mine is in line with the motor mounting bolts. About 190mm from the right edge of the machine head.

I saw a drawing a while ago that had it at 182mm from the right edge.

Edited by JJN
Added content

Ferdco Juki Pro-2000, Juki DNU-1541S, LS-1341, LU-563, DLN-9010A-SH, MO-6714S,  Consew 206RB, 206RB-1, Chandler/Bernina 217 6mm w/Cam Reader, Brother LT2-B842-5

  • 8 months later...
  • Members
Posted

Anyone know where you can get the return spring as mine is missing ...thanks in advance

  • Members
Posted
12 hours ago, Brock0505 said:

Anyone know where you can get the return spring as mine is missing ...thanks in advance

I bought one from Ebay a few years ago. Consew 206s are exceptionally popular, so parts are redily available. I think Ive bought most of my parts from Bob Kovar at Toledo Industrial Sewing supply. 

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...