Hildebrand Report post Posted November 2, 2020 Title says it. I have a couple belts for my granddaughters and I would like to sew them but I only have about 3/16” between the tooling boarder and the belt edge. Thank you. Todd Quote Share this post Link to post Share on other sites
Constabulary Report post Posted November 2, 2020 depends on the needle and thread size you want to use. I would test this on some scrap leather. Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted November 2, 2020 Do you have the inline feet? Quote Share this post Link to post Share on other sites
garypl Report post Posted November 2, 2020 Bob, do you sell inline feet for the 4500? Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted November 22, 2020 Watch a Cowboy CB4500 sewing along a belt edge with the inline feet. I got them from Bob at Toledo Industrial Sewing Machines. Quote Share this post Link to post Share on other sites
garypl Report post Posted November 22, 2020 Thanks Wiz - those look to do a great job! I was thinking about getting a set but they are a bit more expensive than I thought. I will wait until I have a definite requirement for this type of set and then order them! Quote Share this post Link to post Share on other sites
